[vc_row][vc_column][vc_column_text]

Routing optimization and Chip Finishing

 

Author: Avik Sumed Arun, Physical Design Engineer, SignOff Semiconductors Pvt Ltd[/vc_column_text][vc_column_text]

ROUTING OPTIMIZATION

This post will concentrate on Finding & Fixing Antenna violations and Redundant via insertion. The other topic will be covered in subsequent posts.

[/vc_column_text][vc_column_text]

Antenna Violations

In order to prevent antenna problems, tools verify that for each input pin the metal antenna area divided by the gate area is less than the maximum antenna ratio given by the foundry:

(Antenna area) ⁄ (Gate area) <  (Max Antenna ratio)

 

Gate area: The are of transistors which is the intersection of the diffusion and the polysilicon layers.

Antenna area: Total area of metal connected to gate terminal.

Max Antenna Ratio: Maximum allowable ratio of Antenna area to Gate area.

Fixing antenna violations

There are many techniques to fix antenna violations. The widely used techniques are described in this post.

[/vc_column_text][vc_column_text]

Antenna Diode:

Fig1: Antenna Diode.

[/vc_column_text][vc_column_text]

Limitations of using antenna diodes:

Fig2: Back to Back connected Antenna diode.

[/vc_column_text][vc_column_text]

Use of Jumpers (metal Hopping):

Fig3: Jumpers (metal hopping)

Fig4: Jumper insertion for analog block.

Fig5: Jumper insertion for High Fanout nets.

[/vc_column_text][vc_column_text]

Redundant Via Insertion / Double Via Insertion.

Fig6: Redundant via insertion.

[/vc_column_text][vc_column_text]

Chip Finishing

Chip finish is a stage after post-route optimization, where filler cells and metal fills are added to meet the DRC rules. The different steps in chip finish are briefly described below.

Inserting Filler Cells

Inserting Metal Fills (Dummy Metal Fills)

[/vc_column_text][/vc_column][/vc_row]